Thanks to clf-gas as I wouldn't have worked it out otherwise, agree with nojo608 that it annoying that there's nothing about this on the Duravit website! Once you've tightened the bolt, with a philips screwdriver, you can clip on the covers can and then refix the seat. Incidentally, I have a Happy D soft close toilet seat but I gather then fixings are identical.
Hello all, after scrolling the web and Duravit website I finally worked outĪnd completed the process on how to tighten up the circular plates that secure the Duravit Starck 3 toilet seat in place.
Its very simple, but if your not shown you would probably never figure it out.Ī. Lift seat and lid to fully upright position.ī. Place hands under edge of seat and pull upwards to remove from upright pins connected to circular plates on bowl. Its very likely this has never been done since you have owned the toilet (otherwise you wouldn't need to read this) so it is very likely some extra force needs to be used.
The upright pins have a rubber seal/washer that can get a bit grubby which makes pulling the seat off a little tricky first.Ĭ. The circular plates and upright pins will now be exposed. Now find a small flat head screw drivers and very carefully remove the silver circular covers by working your way around the outer perimeter of the silver plates.ĭ.
0 kommentar(er)
